Samsung Galaxy Note Edge N915PVPU4DPD1
SM-N915P 1 country Android 6.0.1 (Lollipop)

Samsung Galaxy Note Edge N915PVPU4DPD1 Firmware

Samsung Galaxy Note Edge N915PVPU4DPD1 is an Android 6.0.1 (Lollipop) firmware for United States (SPR, XAS). It is the same firmware configured per region and carrier (CSC). Find your country below, verify the file and download for free. Compared with the previous build N915PVPS4COK2: Android updated from Android 5.1.1 (Lollipop) to Android 6.0.1 (Lollipop). A newer build for SM-N915P is available: N915PVPU5DQI5.

Download firmware
8.8/10 (456)8,702 times
Android 6.0.1 (Lollipop)
OS Version
2016-04-01
Build Date
1
Countries
2
CSC codes
4
Bootloader binary

Bootloader binary 4. Flashing firmware with a lower binary is usually blocked by Samsung anti-rollback.

Newer builds of Samsung Galaxy Note Edge use bootloader binary 5 (latest: N915PVPU5DQI5). If your device already runs binary 5, this build cannot be flashed.

All regional downloads

Pick your region (CSC) to download the matching firmware package.

Paste your current build number from Settings > About phone (About tablet) > Software information, or the output of *#1234#.
    MODEM/CP Version: N915PVPU4DPD1
    ModelRegionCSC VersionRelease dateSizeFile nameDownload
    SM-N915P
    SPR, XAS United States
    		N915PSPT4DPD1 2016-04-21 2.212 GiB
    SM-N915P_1_20171025151840_z06exxf5fg_fac.zip

    No matching downloads

    How to flash N915PVPU4DPD1

    • N915PVPU4DPD1 has bootloader binary 4. Your device must run binary 4 or lower: it is the 5th character from the end of your current build number.
    • CSC: Use CSC for a clean install, to change the region (CSC code), to downgrade or to repair a device that does not boot.
    • HOME_CSC: Use HOME_CSC to update the same model and region while keeping your data. Back up anyway: a failed update can still require a reset.
    • The Download Mode key combo depends on the model: see all combos.
    Full flashing guide
    Beware: Manually flashing firmwares may brick your device. Use it at your own risk and follow our tutorial steps.

    Rollout of N915PVPU4DPD1 by region

    Samsung released this build in all regions (2) on the same day, April 21, 2016.

    Device specifications

    • Display diagonal14.2 cm (5.6")
    • Display resolution2560 x 1440 pixels
    • Display typeSAMOLED
    • RAM3 GB
    • Rear camera resolution16 MP
    • Rear camera typeSingle camera
    • Battery capacity3000 mAh
    • Weight174 g

    Specifications of SM-N915F, a regional variant of the same device. Chipset and SIM lines are left out: they can differ by region.

    Frequently Asked Questions

    N915PVPU4DPD1 is Android 6.0.1 (Lollipop) firmware for Samsung Galaxy Note Edge, released for United States (SPR, XAS). Samsung built it on 2016-04-01.

    No. A newer build for SM-N915P is available: N915PVPU5DQI5. Install it instead of N915PVPU4DPD1 unless you need this exact version. The previous build was N915PVPS4COK2.

    Download the package for your region (CSC) and unzip it. In Odin, load each file into the slot with the same name: BL, AP, CP (if the package has one) and CSC, or HOME_CSC to keep your data. Odin checks the built-in checksum of every .tar.md5 file before flashing. The download is 2.212 GiB; keep about twice that free on the computer to unzip it. The Samsung Galaxy Note Edge must be on bootloader binary 4 or lower.

    This build uses bootloader binary 4. It can be flashed on a Samsung Galaxy Note Edge running binary 4 or lower; if the device already has a higher binary, Odin stops with "SW REV CHECK FAIL". 18 other builds of this model use the same binary, so you can switch between them in both directions.

    Other builds and changelog for Samsung Galaxy Note Edge

    No changelog details available.
    Model firmware by region