Samsung Galaxy Tab (3G + WiFi) (Latin) P1000LVJJME Firmware
Samsung Galaxy Tab (3G + WiFi) (Latin) P1000LVJJME is an Android 2.2.1 (Froyo) firmware for Chile (CHO). It is the same firmware configured per region and carrier (CSC). Find your country below, verify the file and download for free. Compared with the previous build P1000LVIJR2 https://samfirm.shop/build/P1000LVIJR2: Android updated from Android 2.3.6 (Gingerbread) to Android 2.2.1 (Froyo). This is the newest build for GT-P1000L.
Android 2.2.1 (Froyo)
OS Version
2011-02-10
Build Date
1
Countries
1
CSC codes
V (31)
Bootloader binary
Bootloader binary V (31). Flashing firmware with a lower binary is usually blocked by Samsung anti-rollback.
All regional downloads
Pick your region (CSC) to download the matching firmware package.
Paste your current build number from Settings > About phone (About tablet) > Software information, or the output of *#1234#.
MODEM/CP Version: P1000LCHOJM1
| Model | Region | CSC Version | Size | File name | Download |
|---|---|---|---|---|---|
| GT-P1000L |
CHO Chile | P1000LVJJMA | — | — | Download |
No matching downloads
How to flash P1000LVJJME
- P1000LVJJME has bootloader binary V (31). Your device must run binary V (31) or lower: it is the 5th character from the end of your current build number.
- CSC: Use CSC for a clean install, to change the region (CSC code), to downgrade or to repair a device that does not boot.
- HOME_CSC: Use HOME_CSC to update the same model and region while keeping your data. Back up anyway: a failed update can still require a reset.
- The Download Mode key combo depends on the model: see all combos.
Beware: Manually flashing firmwares may brick your device. Use it at your own risk and follow our tutorial steps.
Frequently Asked Questions
P1000LVJJME is Android 2.2.1 (Froyo) firmware for Samsung Galaxy Tab (3G + WiFi) (Latin), released for Chile (CHO). Samsung built it on 2011-02-10.
Yes. P1000LVJJME is the newest build for GT-P1000L on SamFirm. The previous build was P1000LVIJR2.
Download the package for your region (CSC) and unzip it. In Odin, load each file into the slot with the same name: BL, AP, CP (if the package has one) and CSC, or HOME_CSC to keep your data. Odin checks the built-in checksum of every .tar.md5 file before flashing. The Samsung Galaxy Tab (3G + WiFi) (Latin) must be on bootloader binary V (31) or lower.
This build uses bootloader binary V (31). It can be flashed on a Samsung Galaxy Tab (3G + WiFi) (Latin) running binary V (31) or lower; if the device already has a higher binary, Odin stops with "SW REV CHECK FAIL". 1 other build of this model uses the same binary, so you can switch between them in both directions.
Other builds and changelog for Samsung Galaxy Tab (3G + WiFi) (Latin)
No changelog details available.
- P1000LVJJMEFeb 10, 2011
- P1000LVIJR2Nov 30, 2011
- P1000LUTJP8Aug 4, 2011