Samsung Galaxy Tab 7.0 Plus P6200LDCME1
GT-P6200L 1 country

Samsung Galaxy Tab 7.0 Plus P6200LDCME1 Firmware

Samsung Galaxy Tab 7.0 Plus P6200LDCME1 is an Android firmware for Thailand (THL). It is the same firmware configured per region and carrier (CSC). Find your country below, verify the file and download for free. A newer build for GT-P6200L is available: P6200LVSMH1.

Download firmware
8.7/10 (479)4,337 times
2013-05-03
Build Date
1
Countries
1
CSC codes
D (13)
Bootloader binary

Bootloader binary D (13). Flashing firmware with a lower binary is usually blocked by Samsung anti-rollback.

Newer builds of Samsung Galaxy Tab 7.0 Plus use bootloader binary V (31) (latest: P6200LVSMH1). If your device already runs binary V (31), this build cannot be flashed.

All regional downloads

Pick your region (CSC) to download the matching firmware package.

Paste your current build number from Settings > About phone (About tablet) > Software information, or the output of *#1234#.
    MODEM/CP Version: P6200LDCMD2
    ModelRegionCSC VersionRelease dateSizeFile nameDownload
    GT-P6200L
    THL Thailand
    		P6200LTHLME1 2013-05-21 — — Download

    No matching downloads

    How to flash P6200LDCME1

    • P6200LDCME1 has bootloader binary D (13). Your device must run binary D (13) or lower: it is the 5th character from the end of your current build number.
    • CSC: Use CSC for a clean install, to change the region (CSC code), to downgrade or to repair a device that does not boot.
    • HOME_CSC: Use HOME_CSC to update the same model and region while keeping your data. Back up anyway: a failed update can still require a reset.
    • The Download Mode key combo depends on the model: see all combos.
    Full flashing guide
    Beware: Manually flashing firmwares may brick your device. Use it at your own risk and follow our tutorial steps.

    Frequently Asked Questions

    No. A newer build for GT-P6200L is available: P6200LVSMH1. Install it instead of P6200LDCME1 unless you need this exact version.

    Download the package for your region (CSC) and unzip it. In Odin, load each file into the slot with the same name: BL, AP, CP (if the package has one) and CSC, or HOME_CSC to keep your data. Odin checks the built-in checksum of every .tar.md5 file before flashing. The Samsung Galaxy Tab 7.0 Plus must be on bootloader binary D (13) or lower.

    This build uses bootloader binary D (13). It can be flashed on a Samsung Galaxy Tab 7.0 Plus running binary D (13) or lower; if the device already has a higher binary, Odin stops with "SW REV CHECK FAIL". 1 other build of this model uses the same binary, so you can switch between them in both directions.

    Other builds and changelog for Samsung Galaxy Tab 7.0 Plus

    No changelog details available.
    Model firmware by region