Samsung Galaxy Xcover2 S7710XXAMB6 Firmware
Samsung Galaxy Xcover2 S7710XXAMB6 is an Android 4.1.2 firmware for Ukraine (SEK). It is the same firmware configured per region and carrier (CSC). Find your country below, verify the file and download for free. Compared with the previous build S7710XXAMB5: Android updated from Jelly(Android Bean) to Android 4.1.2. A newer build for GT-S7710 is available: S7710XXAOB2.
9.3/10 (470)4,411 times
Android 4.1.2
OS Version
2013-02-25
Build Date
n/a
Security patch
1
Countries
1
CSC codes
X (33)
Bootloader binary
Bootloader binary X (33). Flashing firmware with a lower binary is usually blocked by Samsung anti-rollback.
All regional downloads
Pick your region (CSC) to download the matching firmware package.
Paste your current build number from Settings > About phone (About tablet) > Software information, or the output of *#1234#.
MODEM/CP Version: S7710XXAMB6
Device specifications
- Launched withAndroid 4.1
- Display diagonal10.2 cm (4")
- Display resolution480 x 800 pixels
- Display typeTFT
- Processor frequency1 GHz
- Rear camera resolution5 MP
- Rear camera typeSingle camera
- SIM cardsSingle SIM
- Battery capacity1700 mAh
- Weight148 g
How to flash S7710XXAMB6
- Install Samsung USB Drivers:Download Official Drivers
- Download Odin Flash Tool:
- S7710XXAMB6 has bootloader binary X (33). Your device must run binary X (33) or lower: it is the 5th character from the end of your current build number.
- CSC: Use CSC for a clean install, to change the region (CSC code), to downgrade or to repair a device that does not boot.
- HOME_CSC: Use HOME_CSC to update the same model and region while keeping your data. Back up anyway: a failed update can still require a reset.
- The Download Mode key combo depends on the model: see all combos.
Beware: Manually flashing firmwares may brick your device. Use it at your own risk and follow our tutorial steps.
Frequently Asked Questions
S7710XXAMB6 is Android 4.1.2 firmware for Samsung Galaxy Xcover2, released for Ukraine (SEK). Samsung built it on 2013-02-25.
No. A newer build for GT-S7710 is available: S7710XXAOB2. Install it instead of S7710XXAMB6 unless you need this exact version. The previous build was S7710XXAMB5.
Download the package for your region (CSC) and unzip it. In Odin, load each file into the slot with the same name: BL, AP, CP (if the package has one) and CSC, or HOME_CSC to keep your data. Odin checks the built-in checksum of every .tar.md5 file before flashing. The Samsung Galaxy Xcover2 must be on bootloader binary X (33) or lower.
This build uses bootloader binary X (33). It can be flashed on a Samsung Galaxy Xcover2 running binary X (33) or lower; if the device already has a higher binary, Odin stops with "SW REV CHECK FAIL". 25 other builds of this model use the same binary, so you can switch between them in both directions.