Samsung GT-S5300 S5300XXLJ4 Firmware
Samsung GT-S5300 S5300XXLJ4 is an Android 2.3.6 (Gingerbread) firmware for 6 countries, 7 CSC codes. It is the same firmware configured per region and carrier (CSC). Find your country below, verify the file and download for free. Compared with the previous build S5300XXLG2, Android and the bootloader binary are unchanged, so you can switch between the two in both directions. A newer build for GT-S5300 is available: S5300XXMD1.
9.2/10 (487)34,709 times
Android 2.3.6 (Gingerbread)
OS Version
2012-11-05
First release
other regions until 2013-10-07
n/a
Security patch
6
Countries
7
CSC codes
X (33)
Bootloader binary
Bootloader binary X (33). Flashing firmware with a lower binary is usually blocked by Samsung anti-rollback.
All regional downloads
Pick your region (CSC) to download the matching firmware package.
Paste your current build number from Settings > About phone (About tablet) > Software information, or the output of *#1234#.
Your CSC is in Settings → About phone (About tablet) → Software information, or dial *#1234#. The CSC sets your region's features and network bands. Download the firmware for your country.
No matching downloads
Device specifications
- Launched withAndroid 2.3
- Display diagonal7.11 cm (2.8")
- Display resolution320 x 240 pixels
- Display typeTFT
- Processor frequency0.832 GHz
- Processor familyBroadcom
- Rear camera resolution2 MP
- Rear camera typeSingle camera
- SIM cardsSingle SIM
- Battery capacity1200 mAh
- Weight95.5 g
How to flash S5300XXLJ4
- Install Samsung USB Drivers:Download Official Drivers
- Download Odin Flash Tool:
- S5300XXLJ4 has bootloader binary X (33). Your device must run binary X (33) or lower: it is the 5th character from the end of your current build number.
- CSC: Use CSC for a clean install, to change the region (CSC code), to downgrade or to repair a device that does not boot.
- HOME_CSC: Use HOME_CSC to update the same model and region while keeping your data. Back up anyway: a failed update can still require a reset.
- The Download Mode key combo depends on the model: see all combos.
Beware: Manually flashing firmwares may brick your device. Use it at your own risk and follow our tutorial steps.
Frequently Asked Questions
S5300XXLJ4 is Android 2.3.6 (Gingerbread) firmware for Samsung GT-S5300, released for 6 countries, 7 CSC codes. Samsung built it on 2012-11-05.
No. A newer build for GT-S5300 is available: S5300XXMD1. Install it instead of S5300XXLJ4 unless you need this exact version. The previous build was S5300XXLG2.
Download the package for your region (CSC) and unzip it. In Odin, load each file into the slot with the same name: BL, AP, CP (if the package has one) and CSC, or HOME_CSC to keep your data. Odin checks the built-in checksum of every .tar.md5 file before flashing. The Samsung GT-S5300 must be on bootloader binary X (33) or lower.
This build uses bootloader binary X (33). It can be flashed on a Samsung GT-S5300 running binary X (33) or lower; if the device already has a higher binary, Odin stops with "SW REV CHECK FAIL". 3 other builds of this model use the same binary, so you can switch between them in both directions.
Other builds and changelog for Samsung GT-S5300
No changelog details available.