Samsung GT-S6500D S6500DBGMK1 Firmware
Samsung GT-S6500D S6500DBGMK1 is an Android 2.3.6 (Gingerbread) firmware for Spain (XEC). It is the same firmware configured per region and carrier (CSC). Find your country below, verify the file and download for free. A newer build for GT-S6500D is available: S6500DZSLI2.
8.7/10 (470)4,207 times
Android 2.3.6 (Gingerbread)
OS Version
2013-11-14
Build Date
n/a
Security patch
1
Countries
1
CSC codes
B (11)
Bootloader binary
Bootloader binary B (11). Flashing firmware with a lower binary is usually blocked by Samsung anti-rollback.
Newer builds of Samsung GT-S6500D use bootloader binary Z (35) (latest: S6500DZSLI2). If your device already runs binary Z (35), this build cannot be flashed.
All regional downloads
Pick your region (CSC) to download the matching firmware package.
Paste your current build number from Settings > About phone (About tablet) > Software information, or the output of *#1234#.
MODEM/CP Version: S6500DXXMK1
How to flash S6500DBGMK1
- Install Samsung USB Drivers:Download Official Drivers
- Download Odin Flash Tool:
- S6500DBGMK1 has bootloader binary B (11). Your device must run binary B (11) or lower: it is the 5th character from the end of your current build number.
- CSC: Use CSC for a clean install, to change the region (CSC code), to downgrade or to repair a device that does not boot.
- HOME_CSC: Use HOME_CSC to update the same model and region while keeping your data. Back up anyway: a failed update can still require a reset.
- The Download Mode key combo depends on the model: see all combos.
Beware: Manually flashing firmwares may brick your device. Use it at your own risk and follow our tutorial steps.
Frequently Asked Questions
S6500DBGMK1 is Android 2.3.6 (Gingerbread) firmware for Samsung GT-S6500D, released for Spain (XEC). Samsung built it on 2013-11-14.
No. A newer build for GT-S6500D is available: S6500DZSLI2. Install it instead of S6500DBGMK1 unless you need this exact version.
Download the package for your region (CSC) and unzip it. In Odin, load each file into the slot with the same name: BL, AP, CP (if the package has one) and CSC, or HOME_CSC to keep your data. Odin checks the built-in checksum of every .tar.md5 file before flashing. The Samsung GT-S6500D must be on bootloader binary B (11) or lower.
This build uses bootloader binary B (11). It can be flashed on a Samsung GT-S6500D running binary B (11) or lower; if the device already has a higher binary, Odin stops with "SW REV CHECK FAIL". No other build of this model uses binary B (11).