Samsung GT-S6500D S6500DZCLH1
GT-S6500D 1 country Android 2.3.6 (Gingerbread)

Samsung GT-S6500D S6500DZCLH1 Firmware

Samsung GT-S6500D S6500DZCLH1 is an Android 2.3.6 (Gingerbread) firmware for China (CHN). It is the same firmware configured per region and carrier (CSC). Find your country below, verify the file and download for free. Compared with the previous build S6500DXXMK1: bootloader binary raised from X (33) to Z (35), so after installing it there is no way back to older builds. A newer build for GT-S6500D is available: S6500DZSLI2.

9.3/10 (482)3,398 times
Android 2.3.6 (Gingerbread)
OS Version
2012-08-28
Build Date
n/a
Security patch
1
Countries
1
CSC codes
Z (35)
Bootloader binary

Bootloader binary Z (35). Flashing firmware with a lower binary is usually blocked by Samsung anti-rollback.

All regional downloads

Pick your region (CSC) to download the matching firmware package.

Paste your current build number from Settings > About phone (About tablet) > Software information, or the output of *#1234#.
    MODEM/CP Version: S6500DZCLH1
    ModelRegionCSC VersionRelease dateSizeFile nameDownload
    GT-S6500D
    CHN China
    		S6500DCHNLH1 2012-09-03 243.943 MiB
    GT-S6500D_CHN_1_20120828155503_n3x94mpiak.zip

    No matching downloads

    How to flash S6500DZCLH1

    • S6500DZCLH1 has bootloader binary Z (35). Your device must run binary Z (35) or lower: it is the 5th character from the end of your current build number.
    • CSC: Use CSC for a clean install, to change the region (CSC code), to downgrade or to repair a device that does not boot.
    • HOME_CSC: Use HOME_CSC to update the same model and region while keeping your data. Back up anyway: a failed update can still require a reset.
    • The Download Mode key combo depends on the model: see all combos.
    Full flashing guide
    Beware: Manually flashing firmwares may brick your device. Use it at your own risk and follow our tutorial steps.

    Frequently Asked Questions

    S6500DZCLH1 is Android 2.3.6 (Gingerbread) firmware for Samsung GT-S6500D, released for China (CHN). Samsung built it on 2012-08-28.

    No. A newer build for GT-S6500D is available: S6500DZSLI2. Install it instead of S6500DZCLH1 unless you need this exact version. The previous build was S6500DXXMK1.

    Download the package for your region (CSC) and unzip it. In Odin, load each file into the slot with the same name: BL, AP, CP (if the package has one) and CSC, or HOME_CSC to keep your data. Odin checks the built-in checksum of every .tar.md5 file before flashing. The download is 243.943 MiB; keep about twice that free on the computer to unzip it. The Samsung GT-S6500D must be on bootloader binary Z (35) or lower.

    This build uses bootloader binary Z (35). It can be flashed on a Samsung GT-S6500D running binary Z (35) or lower; if the device already has a higher binary, Odin stops with "SW REV CHECK FAIL". 1 other build of this model uses the same binary, so you can switch between them in both directions.

    Other builds and changelog for Samsung GT-S6500D

    No changelog details available.
    Model firmware by region