Samsung Galaxy FAME Lite S6790XWANA1
GT-S6790 1 country Android 4.1.2 (Jelly)

Samsung Galaxy FAME Lite S6790XWANA1 Firmware

Samsung Galaxy FAME Lite S6790XWANA1 is an Android 4.1.2 (Jelly) firmware for Kenya (AFR). It is the same firmware configured per region and carrier (CSC). Find your country below, verify the file and download for free. Compared with the previous build S6790ZSAMK2: Android updated from Android 4.1.2 (Jelly Bean) to Android 4.1.2 (Jelly); bootloader binary raised from S (28) to W (32), so after installing it there is no way back to older builds. A newer build for GT-S6790 is available: S6790XXANJ1.

Download firmware
9.1/10 (476)4,329 times
Android 4.1.2 (Jelly)
OS Version
2014-01-13
Build Date
1
Countries
1
CSC codes
W (32)
Bootloader binary

Bootloader binary W (32). Flashing firmware with a lower binary is usually blocked by Samsung anti-rollback.

Newer builds of Samsung Galaxy FAME Lite use bootloader binary X (33) (latest: S6790XXANJ1). If your device already runs binary X (33), this build cannot be flashed.

All regional downloads

Pick your region (CSC) to download the matching firmware package.

Paste your current build number from Settings > About phone (About tablet) > Software information, or the output of *#1234#.
    MODEM/CP Version: S6790XXAMI1
    ModelRegionCSC VersionSizeFile nameDownload
    GT-S6790
    AFR Kenya
    		S6790OJVANA1 600.033 MiB
    GT-S6790_1_20150925135653_t9zk519wkf_fac.zip

    No matching downloads

    How to flash S6790XWANA1

    • S6790XWANA1 has bootloader binary W (32). Your device must run binary W (32) or lower: it is the 5th character from the end of your current build number.
    • CSC: Use CSC for a clean install, to change the region (CSC code), to downgrade or to repair a device that does not boot.
    • HOME_CSC: Use HOME_CSC to update the same model and region while keeping your data. Back up anyway: a failed update can still require a reset.
    • The Download Mode key combo depends on the model: see all combos.
    Full flashing guide
    Beware: Manually flashing firmwares may brick your device. Use it at your own risk and follow our tutorial steps.

    Device specifications

    • Launched withAndroid 4.1
    • Display diagonal8.89 cm (3.5")
    • Display resolution480 x 320 pixels
    • Display typeTFT
    • Processor frequency0.85 GHz
    • Rear camera resolution3 MP
    • Rear camera typeSingle camera
    • Battery capacity1300 mAh
    • Weight118 g

    Frequently Asked Questions

    S6790XWANA1 is Android 4.1.2 (Jelly) firmware for Samsung Galaxy FAME Lite, released for Kenya (AFR). Samsung built it on 2014-01-13.

    No. A newer build for GT-S6790 is available: S6790XXANJ1. Install it instead of S6790XWANA1 unless you need this exact version. The previous build was S6790ZSAMK2.

    Download the package for your region (CSC) and unzip it. In Odin, load each file into the slot with the same name: BL, AP, CP (if the package has one) and CSC, or HOME_CSC to keep your data. Odin checks the built-in checksum of every .tar.md5 file before flashing. The download is 600.033 MiB; keep about twice that free on the computer to unzip it. The Samsung Galaxy FAME Lite must be on bootloader binary W (32) or lower.

    This build uses bootloader binary W (32). It can be flashed on a Samsung Galaxy FAME Lite running binary W (32) or lower; if the device already has a higher binary, Odin stops with "SW REV CHECK FAIL". 3 other builds of this model use the same binary, so you can switch between them in both directions.

    Other builds and changelog for Samsung Galaxy FAME Lite

    No changelog details available.
    Model firmware by region