Samsung GT-S7500 S7500DXMG3 Firmware
Samsung GT-S7500 S7500DXMG3 is an Android 2.3.6 (Gingerbread) firmware for Philippines (GLB, SMA). It is the same firmware configured per region and carrier (CSC). Find your country below, verify the file and download for free. Compared with the previous build S7500DDMF2, Android and the bootloader binary are unchanged, so you can switch between the two in both directions. A newer build for GT-S7500 is available: S7500ZULH1.
9.0/10 (475)7,662 times
Android 2.3.6 (Gingerbread)
OS Version
2013-07-22
First release
other regions until 2013-08-21
n/a
Security patch
1
Countries
2
CSC codes
D (13)
Bootloader binary
Bootloader binary D (13). Flashing firmware with a lower binary is usually blocked by Samsung anti-rollback.
Newer builds of Samsung GT-S7500 use bootloader binary Z (35) (latest: S7500ZULH1). If your device already runs binary Z (35), this build cannot be flashed.
All regional downloads
Pick your region (CSC) to download the matching firmware package.
Paste your current build number from Settings > About phone (About tablet) > Software information, or the output of *#1234#.
MODEM/CP Version: S7500DXMG1
How to flash S7500DXMG3
- Install Samsung USB Drivers:Download Official Drivers
- Download Odin Flash Tool:
- S7500DXMG3 has bootloader binary D (13). Your device must run binary D (13) or lower: it is the 5th character from the end of your current build number.
- CSC: Use CSC for a clean install, to change the region (CSC code), to downgrade or to repair a device that does not boot.
- HOME_CSC: Use HOME_CSC to update the same model and region while keeping your data. Back up anyway: a failed update can still require a reset.
- The Download Mode key combo depends on the model: see all combos.
Beware: Manually flashing firmwares may brick your device. Use it at your own risk and follow our tutorial steps.
Frequently Asked Questions
S7500DXMG3 is Android 2.3.6 (Gingerbread) firmware for Samsung GT-S7500, released for Philippines (GLB, SMA). Samsung built it on 2013-07-22.
No. A newer build for GT-S7500 is available: S7500ZULH1. Install it instead of S7500DXMG3 unless you need this exact version. The previous build was S7500DDMF2.
Download the package for your region (CSC) and unzip it. In Odin, load each file into the slot with the same name: BL, AP, CP (if the package has one) and CSC, or HOME_CSC to keep your data. Odin checks the built-in checksum of every .tar.md5 file before flashing. The download is 257.908 MiB; keep about twice that free on the computer to unzip it. The Samsung GT-S7500 must be on bootloader binary D (13) or lower.
This build uses bootloader binary D (13). It can be flashed on a Samsung GT-S7500 running binary D (13) or lower; if the device already has a higher binary, Odin stops with "SW REV CHECK FAIL". 2 other builds of this model use the same binary, so you can switch between them in both directions.
Other builds and changelog for Samsung GT-S7500
Show 15 older builds
No changelog details available.