Samsung Galaxy S Advance I9070VSLPA
GT-I9070 1 country Android 4.1.2 (Jelly Bean)

Samsung Galaxy S Advance I9070VSLPA Firmware

Samsung Galaxy S Advance I9070VSLPA is an Android 4.1.2 (Jelly Bean) firmware for Argentina (UFN). It is the same firmware configured per region and carrier (CSC). Find your country below, verify the file and download for free. Compared with the previous build I9070VSLP9, Android and the bootloader binary are unchanged, so you can switch between the two in both directions. A newer build for GT-I9070 is available: I9070ZSMG2.

8.7/10 (482)3,168 times
Android 4.1.2 (Jelly Bean)
OS Version
2013-11-07
Build Date
n/a
Security patch
1
Countries
1
CSC codes
V (31)
Bootloader binary

Bootloader binary V (31). Flashing firmware with a lower binary is usually blocked by Samsung anti-rollback.

Newer builds of Samsung Galaxy S Advance use bootloader binary Z (35) (latest: I9070ZSMG2). If your device already runs binary Z (35), this build cannot be flashed.

All regional downloads

Pick your region (CSC) to download the matching firmware package.

Paste your current build number from Settings > About phone (About tablet) > Software information, or the output of *#1234#.
    MODEM/CP Version: I9070VSLPA
    ModelRegionCSC VersionRelease dateSizeFile nameDownload
    GT-I9070
    UFN Argentina
    		I9070TFGLPA 2013-11-07 462.298 MiB
    GT-I9070_UFN_1_20131106143800_o4ubltvpof.zip

    No matching downloads

    How to flash I9070VSLPA

    • I9070VSLPA has bootloader binary V (31). Your device must run binary V (31) or lower: it is the 5th character from the end of your current build number.
    • CSC: Use CSC for a clean install, to change the region (CSC code), to downgrade or to repair a device that does not boot.
    • HOME_CSC: Use HOME_CSC to update the same model and region while keeping your data. Back up anyway: a failed update can still require a reset.
    • The Download Mode key combo depends on the model: see all combos.
    Full flashing guide
    Beware: Manually flashing firmwares may brick your device. Use it at your own risk and follow our tutorial steps.

    Frequently Asked Questions

    I9070VSLPA is Android 4.1.2 (Jelly Bean) firmware for Samsung Galaxy S Advance, released for Argentina (UFN). Samsung built it on 2013-11-07.

    No. A newer build for GT-I9070 is available: I9070ZSMG2. Install it instead of I9070VSLPA unless you need this exact version. The previous build was I9070VSLP9.

    Download the package for your region (CSC) and unzip it. In Odin, load each file into the slot with the same name: BL, AP, CP (if the package has one) and CSC, or HOME_CSC to keep your data. Odin checks the built-in checksum of every .tar.md5 file before flashing. The download is 462.298 MiB; keep about twice that free on the computer to unzip it. The Samsung Galaxy S Advance must be on bootloader binary V (31) or lower.

    This build uses bootloader binary V (31). It can be flashed on a Samsung Galaxy S Advance running binary V (31) or lower; if the device already has a higher binary, Odin stops with "SW REV CHECK FAIL". 4 other builds of this model use the same binary, so you can switch between them in both directions.

    Other builds and changelog for Samsung Galaxy S Advance

    No changelog details available.
    Model firmware by region