Samsung Galaxy S Advance I9070VJLPE
GT-I9070 1 country

Samsung Galaxy S Advance I9070VJLPE Firmware

Samsung Galaxy S Advance I9070VJLPE is an Android firmware for Brazil (ZTM). It is the same firmware configured per region and carrier (CSC). Find your country below, verify the file and download for free. Compared with the previous build I9070JVBMD1, Android and the bootloader binary are unchanged, so you can switch between the two in both directions. A newer build for GT-I9070 is available: I9070ZSMG2.

Download firmware
9.3/10 (478)4,220 times
2014-08-06
Build Date
1
Countries
1
CSC codes
V (31)
Bootloader binary

Bootloader binary V (31). Flashing firmware with a lower binary is usually blocked by Samsung anti-rollback.

Newer builds of Samsung Galaxy S Advance use bootloader binary Z (35) (latest: I9070ZSMG2). If your device already runs binary Z (35), this build cannot be flashed.

All regional downloads

Pick your region (CSC) to download the matching firmware package.

Paste your current build number from Settings > About phone (About tablet) > Software information, or the output of *#1234#.
    MODEM/CP Version: I9070VJLPE
    ModelRegionCSC VersionRelease dateSizeFile nameDownload
    GT-I9070
    ZTM Brazil
    		I9070ZTMLPE 2014-08-06 — — Download

    No matching downloads

    How to flash I9070VJLPE

    • I9070VJLPE has bootloader binary V (31). Your device must run binary V (31) or lower: it is the 5th character from the end of your current build number.
    • CSC: Use CSC for a clean install, to change the region (CSC code), to downgrade or to repair a device that does not boot.
    • HOME_CSC: Use HOME_CSC to update the same model and region while keeping your data. Back up anyway: a failed update can still require a reset.
    • The Download Mode key combo depends on the model: see all combos.
    Full flashing guide
    Beware: Manually flashing firmwares may brick your device. Use it at your own risk and follow our tutorial steps.

    Frequently Asked Questions

    No. A newer build for GT-I9070 is available: I9070ZSMG2. Install it instead of I9070VJLPE unless you need this exact version. The previous build was I9070JVBMD1.

    Download the package for your region (CSC) and unzip it. In Odin, load each file into the slot with the same name: BL, AP, CP (if the package has one) and CSC, or HOME_CSC to keep your data. Odin checks the built-in checksum of every .tar.md5 file before flashing. The Samsung Galaxy S Advance must be on bootloader binary V (31) or lower.

    This build uses bootloader binary V (31). It can be flashed on a Samsung Galaxy S Advance running binary V (31) or lower; if the device already has a higher binary, Odin stops with "SW REV CHECK FAIL". 4 other builds of this model use the same binary, so you can switch between them in both directions.

    Other builds and changelog for Samsung Galaxy S Advance

    No changelog details available.
    Model firmware by region