Samsung Galaxy Tab 10.1 P7500ZCLPB
GT-P7500 1 country

Samsung Galaxy Tab 10.1 P7500ZCLPB Firmware

Samsung Galaxy Tab 10.1 P7500ZCLPB is an Android firmware for China (CHN). It is the same firmware configured per region and carrier (CSC). Find your country below, verify the file and download for free. Compared with the previous build P7500XXLQ8: bootloader binary raised from X (33) to Z (35), so after installing it there is no way back to older builds. A newer build for GT-P7500 is available: P7500ZSLP8.

Download firmware
9.0/10 (475)4,207 times
2012-12-20
Build Date
1
Countries
1
CSC codes
Z (35)
Bootloader binary

Bootloader binary Z (35). Flashing firmware with a lower binary is usually blocked by Samsung anti-rollback.

All regional downloads

Pick your region (CSC) to download the matching firmware package.

Paste your current build number from Settings > About phone (About tablet) > Software information, or the output of *#1234#.
    MODEM/CP Version: P7500ZCLPB
    ModelRegionCSC VersionRelease dateSizeFile nameDownload
    GT-P7500
    CHN China
    		P7500OZHLPB 2013-02-21 — —

    No matching downloads

    How to flash P7500ZCLPB

    • P7500ZCLPB has bootloader binary Z (35). Your device must run binary Z (35) or lower: it is the 5th character from the end of your current build number.
    • CSC: Use CSC for a clean install, to change the region (CSC code), to downgrade or to repair a device that does not boot.
    • HOME_CSC: Use HOME_CSC to update the same model and region while keeping your data. Back up anyway: a failed update can still require a reset.
    • The Download Mode key combo depends on the model: see all combos.
    Full flashing guide
    Beware: Manually flashing firmwares may brick your device. Use it at your own risk and follow our tutorial steps.

    Frequently Asked Questions

    No. A newer build for GT-P7500 is available: P7500ZSLP8. Install it instead of P7500ZCLPB unless you need this exact version. The previous build was P7500XXLQ8.

    Download the package for your region (CSC) and unzip it. In Odin, load each file into the slot with the same name: BL, AP, CP (if the package has one) and CSC, or HOME_CSC to keep your data. Odin checks the built-in checksum of every .tar.md5 file before flashing. The Samsung Galaxy Tab 10.1 must be on bootloader binary Z (35) or lower.

    This build uses bootloader binary Z (35). It can be flashed on a Samsung Galaxy Tab 10.1 running binary Z (35) or lower; if the device already has a higher binary, Odin stops with "SW REV CHECK FAIL". 1 other build of this model uses the same binary, so you can switch between them in both directions.

    Other builds and changelog for Samsung Galaxy Tab 10.1

    No changelog details available.
    Model firmware by region