Samsung Galaxy S Advance I9070BOLK1 Firmware
Samsung Galaxy S Advance I9070BOLK1 is an Android 2.3.6 (Gingerbread) firmware for Macedonia (MBM), Netherlands (TNL). It is the same firmware configured per region and carrier (CSC). Find your country below, verify the file and download for free. A newer build for GT-I9070 is available: I9070ZSMG2.
8.7/10 (479)6,242 times
Android 2.3.6 (Gingerbread)
OS Version
2013-10-15
Build Date
n/a
Security patch
2
Countries
2
CSC codes
B (11)
Bootloader binary
Bootloader binary B (11). Flashing firmware with a lower binary is usually blocked by Samsung anti-rollback.
Newer builds of Samsung Galaxy S Advance use bootloader binary Z (35) (latest: I9070ZSMG2). If your device already runs binary Z (35), this build cannot be flashed.
All regional downloads
Pick your region (CSC) to download the matching firmware package.
Paste your current build number from Settings > About phone (About tablet) > Software information, or the output of *#1234#.
Your CSC is in Settings → About phone (About tablet) → Software information, or dial *#1234#. The CSC sets your region's features and network bands. Download the firmware for your country.
MODEM/CP Version: I9070XXLK2
How to flash I9070BOLK1
- Install Samsung USB Drivers:Download Official Drivers
- Download Odin Flash Tool:
- I9070BOLK1 has bootloader binary B (11). Your device must run binary B (11) or lower: it is the 5th character from the end of your current build number.
- CSC: Use CSC for a clean install, to change the region (CSC code), to downgrade or to repair a device that does not boot.
- HOME_CSC: Use HOME_CSC to update the same model and region while keeping your data. Back up anyway: a failed update can still require a reset.
- The Download Mode key combo depends on the model: see all combos.
Beware: Manually flashing firmwares may brick your device. Use it at your own risk and follow our tutorial steps.
Frequently Asked Questions
I9070BOLK1 is Android 2.3.6 (Gingerbread) firmware for Samsung Galaxy S Advance, released for Macedonia (MBM), Netherlands (TNL). Samsung built it on 2013-10-15.
No. A newer build for GT-I9070 is available: I9070ZSMG2. Install it instead of I9070BOLK1 unless you need this exact version.
Download the package for your region (CSC) and unzip it. In Odin, load each file into the slot with the same name: BL, AP, CP (if the package has one) and CSC, or HOME_CSC to keep your data. Odin checks the built-in checksum of every .tar.md5 file before flashing. The download is 520.18 MiB; keep about twice that free on the computer to unzip it. The Samsung Galaxy S Advance must be on bootloader binary B (11) or lower.
This build uses bootloader binary B (11). It can be flashed on a Samsung Galaxy S Advance running binary B (11) or lower; if the device already has a higher binary, Odin stops with "SW REV CHECK FAIL". 1 other build of this model uses the same binary, so you can switch between them in both directions.